To change the source addresss of the input channels: MAIN*CONFIGURATION*MATROX*VIDEOOUT_x*SRCUDPPORT SET xxxxx MAIN*CONFIGURATION*MATROX*VIDEOOUT_x*SRCADDRESS SET To change the source address of the output channels: MAIN*CONFIGURATION*MATROX*VIDEOOUT_x*DSTUDPPORT SET xxxxx MAIN*CONFIGURATION*MATROX*VIDEOOUT_x*DSTADDRESS SET To change the destination address of the output channels: Because channel numbering is zero-based here, Output Channel 1 is referred to as VIDEOOUT_0. Here are the default properties for IP input channel 1:Īlthough the IP properties may be changed by editing the configuration file directly, the IP address and port numbers can also be set via the command line interface. Here are the default IP properties for Output channel 1 as shown in the config file: Then launch and quit Viz Artist, in order to rewrite the Viz configuration.ĭefault destination IP settings on output:ĭefault source IP settings for input channels: To view the default values, activate verbose mode by setting VerboseConfig = 1 in the configuration file. In this case, the Use alpha property must be disabled for both channels.īy default, the fields in the configuration file are hidden, at least when set to default values. ![]() Note that it is possible for a dual channel setup to use independent output channels on one SFP, for example 1 and 2.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |